How to set up a Hard Drive essays

How to set up a Hard Drive essays To set up a new hard drive, firstly you need to switch off the power supply and then remove the casing. If you were installing a new hard drive you would have to set the primary hard drive as the master and the new hard drive as a slave. To do this you would have to change the jumpers, the jumpers are located on 3 pins, and these pins should be in-between where the power cable goes and the IDE cable goes. To do this properly you would have to refer to the hard drives manual; it all depends on the hard drive itself. When you checked and changed any jumpers, you can start to put the hard drive into the computer system. If the drive bay is actually bigger than the hard drive you would need a drive bracket to hold it in place. Most modern computers have two bays specially designed to hold more than 1 hard drives. When inserting the hard drive, make sure that no wires or cables are sticking out or get caught, also make sure that the hard drive is the right way up (the label should be at the top). When the drive is inserted, secure the drive with screws provided. Now that the drive is in place, it needs to be connected to the rest of the PC. Firstly connect the IDE cable (the long, wide and grey cable) to the hard drive. This cable should already be connected to the existing hard drive, to make sure that the cable is around the right way, there should be a red line running down the side of the cable, this red line should be closest to the power cable. When the IDE cable is connected, the power cable is the next thing to connect, this power cable runs from the main power supply inside the computer and should have four different coloured wires. This cable can only connect one way. Now the new hard drive is connected, the computer now needs to recognise the new hard drive, to make the computer do this, you would need to enter the computers BIOS. To enter the BIOS, usually you need to press DE ...